Motion Alarm – Bottom Drive For 24V Models Only SKU:7440-11111

Description

******FACTORY INSTALL ONLY***********

The motion alarm monitors the rotation of all rollers. If a belt should break,

Or motor fail in some way, an audible alarm will be produced, and the remote

Alarm jack will be enabled.  This alarm will continue until either the problem

Is fixed, or the alarm is silenced by pressing the “alarm silence” button locate

On the rear of the control box.

Remote alarm jack (provided with motion alarm option)

The remote alarm jack is a 1/4″ phone jack located on the back of the unit. If the operating speed drops to zero, (i.e. Equipment malfunction), a normally open (n-o) dry relay contact will close to enable a remote alarm & power supply.  The contact limits are 1 amp at up to 125 vac or dc. Note that these alarm points are non-latching & non-fail safe & are not intended to provide process monitoring (use the rs-485 port for monitoring).  They are intended to provide a remote signal if the equipment exceeds the design speed range while operating.  External connections are made to the tip & ring circuits of the supplied phone jack.  The shell (ground) connection is not used.